After ESC calibration, we must to it again every time we power off

#1

Hi ,
First thank you , and many thanks to admins and make this great project.

Second, we have problem , when I do ESC calibration, it’s do ok , and motors going great …

But when I power off the battery, the motors don’t power , I must recalibrate again …

Note : I use (Drone dojo kit) .
Note : i have plus+ stepper servo , in output pixhawk (Channel 9) work fine .(as delivery servo)

Can I have help :3

#2

Is there a ‘smoke stopper’ installed? If so, remove it.
It is used only for initial electrical connections, or when changes are made.